MOUNTING OF PROTECTOR
To meet the applicable safety provisions, only the tool/ protector combinations as indicated in the table must be used.
Be sure to use genuine DOLMAR cutter blades or nylon cutting head.
–The cutter blade must be well polished, free of cracks or breakage. If the cutter blade hits against a stone during operation, stop the engine and check the blade immediately.
–Polish or replace the cutter blade every three hours of operation.
–If the nylon cutting head hits against a stone during operation, stop the engine and check the nylon cutting head immediately.
CAUTION : The appropriate protector must always be installed, for your own safety and in order to comply with
Operation of the equipment without the guard being in place is not permitted.
|
|
|
|
| Protector for metal blades |
Star Blade | Protector for metal blades (Use of protector for metal |
| blade/cord cutter) |
|
|
| Protector for cord cutter |
Nylon cutting head | Protector for cord cutter (Use of protector for metal |
| blade/cord cutter) |
For MS-250.4
–The outside diameter of the cutter blade must be 230mm
For MS-250.4, MS-251.4
–Install the clamp (3) on the shaft so that the projection of the clamp (3) is inserted into the opening between the gear case (1) and the shaft. Secure the protector (4) with the installation bolts M6 x 30 (2) and screw M5 x 8 (5).
Use of protector for metal blade / cord cutter.
–In use of the metal blade, fasten the protector (4) to the clamp (3) with two bolts M6 x 30 (2).
NOTE : Tighten the right and left bolts evenly so that the gap between the clamp (3) and the protector (4) will be constant.
Otherwise, the protector sometimes may not function as specified.
(2) | (3) | (1) |
|
(4)
– In use of the cord cutter, insert the protector (2) into the protector (1), and | (1) | (3) |
fasten them with two screw (4) and two nuts (3). |
|
|
(2)
(4)
9
