Dolmar instruction manual Mounting Of Cutter Blade Or Nylon Cutter Head, For MS-250.4, MS-251.4

MOUNTING OF CUTTER BLADE OR NYLON CUTTER HEAD

Turn the machine upside down, and you can replace the cutter blade easily.

For MS-250.4, MS-251.4

–Insert the hex wrench through the hole in the gear case and rotate the receiver washer (3) until it is locked with the hex wrench.

–Loosen the nut (1) (left-hand thread) with the socket wrench and remove the nut (1), and clamp washer (2).

For MS-250.4 with the hex wrench still in place.

–Mount the cutter blade onto the shaft so that the guide of the receiver washer

(3)fits in the arbor hole in the cutter blade. Install the clamp washer (2) and secure the cutter blade with the nut (1).

[Tightening torque: 13 - 23 N-m]

NOTE: Always wear gloves when handling the cutter blade.

NOTE: The cutter blade-fastening nut (with spring washer) is a consumable

part. If there appears any wear or deformation on the spring washer,Hex wrench replace the nut.

Mounting of nylon cutting head

For MS-251.4

–To install the nylon cutting head (7), remove the tightening nut (8).

–Insert the socket-head wrench (11) through the hole in the gear case and tum the support washer until it will be locked with its notch (12) (or the shaft will be locked).

–Then screw the nylon cutting head onto the shaft by turning it counter- clockwise.

–Remove the socket-head wrench.

–Make sure that the blade is the left way up.

Rotation

10