Air_US_rev_111.qxd
To set a Master monitor as System Controller the TC Link button on the rear panel MUST be in
To set a Master monitor as System Controller the TC Link button on the rear panel MUST be in
SETUPS
5.3 Digital Setup
This illustration shows how to connect a 5.3 Digital setup
• Center is set as System Controller by leaving out the TC Link button on the rear panel.
• Left monitor receives both Left and LS signal. The LS monitor is fed via the TC LINK
• Center monitor receives both Center and LFE signal. The LFE monitor is fed via the TC LINK
• Right monitor receives both Right and RS signal. The RS monitor is fed via the TC LINK
• With
• With Bass management “on”:
-Low frequency information from Left and LS is extracted and fed to Left Sub.
-Low frequency information from Right and RS is extracted and fed to Right Sub.
-Low frequency information from Center is extracted, summed with the LFE channel and fed to Center Sub.
•The Remote and/or AIR Soft, can be connected to any available TC LINK Out connection.
5.3 Analog Setup
This illustration shows how to connect a 5.3 Analog setup.
Please see description on 5.3 Digital Setup above regarding
• Left channel to Left Input on the Left monitor.
• Left Surround channel to Right Input on the Left monitor.
• Center channel to the Left Input on the Center monitor.
•LFE channel to the Right Input on the Center monitor.
•Right channel to the Left Input on the Right monitor.
• Right Surround channel to Right Input on the Right monitor.
• The Remote and/or AIR Soft, can be connected to any available TC LINK Out connection.
The setups will ONLY operate correctly if connected according to the illustrations!
12