Dynaudio pmn manual Setups, Digital Setup, With Bass management “on”

Air_US_rev_111.qxd 16-12-2004 14:16 Page 16

To set a Master monitor as System Controller the TC Link button on rear panel MUST be in out-position.

SETUPS

5.3 Digital Setup

This illustration shows how to connect a 5.3 Digital setup with Bass management as an option. The setup requires three Master monitors with the optional Digital AES/EBU I/O card installed, two Slave monitors (or Masters set as Slave) and three Subs.

• Center is set as System Controller by leaving out the TC Link button on the rear panel.

• Left monitor receives both Left and Left Surround signal. The LS monitor is fed via the TC LINK RJ-45 connection from Left to LS.

• Center monitor receives both Center and LFE signal. The LFE monitor is fed via the TC LINK RJ-45 connection from Center to LFE.

• Right monitor receives both Right and Right Surround signal. The RS monitor is fed via the TC LINK RJ-45 connection from Right to RS.

•With Bass-management “off” Left and Right Subs receives no signal.

•With Bass management “on”:

-Low frequency information from Left and LS is extracted and fed to Left Sub.

-Low frequency information from Right and RS is extracted and fed to Right Sub.

-Low frequency information from Center is extracted, summed with the LFE channel and fed to Center Sub.

•The Remote and/or AIR Soft, can be connected to any available TC LINK Out connection.

16