Air_US_rev_111.qxd
THE AIR REMOTE
REF LEVEL 1-3 keys
To recall Reference Level
Press relevant key shortly. The key LED indicates activated Reference Level.
To set Reference Level
Set level using the large VOLUME dialer in the center of the remote. Press and hold relevant Reference level key for approx. 2 seconds. The LED will flash 3 times and then the new Reference level is set.
Power up state: Off (volume defined by potentiometer)
PRESET 1/3 AND 2/4 keys
These keys will recall presets 1/3 & 2/4 depending on the position of the SHIFT key.
Power up state: Off (no presets recalled).
SHIFT key
Combined with the PRESET 1/3 AND 2/4 keys (described above) presets 1 to 4 can be recalled.
Preset Bank 1 is presets 1and 2. Preset bank 2 is presets 3 and 4.
Power up state: Preset Bank 1 selected.
MUTE/UNMUTE - SOLO keys for the channels: L - C - R - Ls - SUB - Rs
The key LEDs indicates the following states:
LED ON | Speaker on |
LED OFF | Speaker Mute |
LED Flashing | Speaker Solo |
Mute/Unmute
With a single press on these keys the monitors are muted/unmuted.
Solo Function
Press and hold one of the keys to activate Solo function for corresponding channel.
All other monitors can enter solo mode simultaneously. If a key is pressed (not held) the original mute status will be recalled.
Power up state: On
VOLUME potentiometer
If no REFERENCE LEVEL keys are activated this control sets the Master volume on all channels in the system.
If one of the REFERENCE LEVEL keys are activated, these will define the reference level.
When REFERENCE LEVEL keys are deactivated Master volume returns to the level defined by the position of the VOLUME potentiometer.
Power up state: Potentiometer setting defines volume level.
Potentiometer LED function:
As soon as the volume level is defined by the potentiometer setting, the LED is on. LED goes off when volume is set by other devices than the remote unit.
Power up state: LED on (Potentiometer setting defines volume level).
45
