Dynaudio pmn manual Stereo Setup With Chains on L & R, Other “Chained” Setups

Air_US_rev_111.qxd 16-12-2004 14:16 Page 14

To set a Master monitor as System Controller the TC Link button on the rear panel MUST be in out-position.

SETUPS

Stereo Setup With Chains on L & R

This illustration shows how to connect a stereo setup with chains on Left and Right.

The chained monitors are fed with the same signal as the front L&R monitors. This the type of setup you would use when you wiish to be able to alternate between a set of main- and nearfiels -monitors.

• Left monitor is set as System Controller by leaving out the TC Link button on the rear panel.

• Left monitor receives both Left and Right Input signal.

• Right monitor receives audio via the TC-LINK RJ-45 connection.

• The Remote and/or AIR Soft, can be connected to any available TC LINK Out connection.

Other “Chained” Setups

From software 1.10 the available setups with “chain” option is: 5.1, 6.1 and 5.3 for analog and digital and well as 5.1/6 master (digital only).

The installed option card will limit the choises of setups presented on the speakers. If the AES/EBU option card is installed, the default digital Input will become Input 1 on the option card.

14