Basic connections and settings

This chapter explains basic connections for the UA-1000 and describes the data flow.

*To prevent malfunction and/or damage to speakers or other devices, always turn down the volume, and turn off the power on all devices before making any connections.

Basic connections

Use a USB cable to connect the UA-1000 to your computer.

Connecting the USB cable allows both MIDI data and audio data to be transferred.

As shown in the diagram, you can connect headphones and/or monitor speakers to monitor the playback of your software or the sound of the instruments or audio devices connected to the UA-1000.

Computer

fig.b

Amplifiedasic speakers

USB cable

USB

Headphones

In the OUTPUT PATCH BAY section of UA-1000 Control Panel, set OUTPUT 1-2 to

“MONITOR OUT.”

(->“Various settings” (p. 36))

When using a mixer

Computer

USB cable

USB

fig.m ixer

Mixer

In the OUTPUT PATCH BAY

section of UA-1000 Control Panel, set OUTPUT 1-2to

WAVE OUT 1-2,OUTPUT 3- 4 to WAVE 3-4 ...OUTPUT 7- 8 to WAVE 7-8.

About the sampling frequency select switch

•You must set the UA-1000’s sampling frequency select switch to the sampling frequency used by your software.

•After you change the setting of the sampling frequency select switch, you must switch off the UA-1000, then turn it on again.

26