Tone Code Channel Screen Description, Stop Timer

PROGRAMMING

	Table 4-5 Scan Function Screen Description (Continued)

Parameter	Description

Stop Timer	When Mode 2 or 3 above is programmed (priority scanning), this sets how often in seconds the priority channel
	is checked while receiving a message on some other channel.

Resume	This sets the scan resume delay in seconds. This is the time that elapses before scanning resumes after a
Timer	message is received.

PWR ON	If this function is programmed “On”, scanning starts automatically when transceiver power is turned on. The
Scan	“Hanger Action” parameter in Table 4-2should also be programmed for “Scan” if power-on scan is used. If
	scanning halts to transmit a message, the timer selected for Auto Reset parameter in the channel screen (see
	Table 4-1)determines the delay before scanning resumes. See also Scan A/B function in Key Assign screen
	(Table 4-2), “Scan” column in 2-Tone Code CH screen (Table 4-6),“Timer A/B” in Common screen
	(Table 4-7), and “Fast/Slow Scan Timer” in Expert screen (Table 4-8).

Auto CH	The parameter is displayed only in the PMR (European) mode, and is used with the 5-tone option. If “On” is
Call	programmed, pressing the CALL key (1) starts scanning, (2) detects a non-busy channel, and (3) transmits the
	5-tone codes.

Table 4-6 2-Tone Code Channel Screen Description

				NOTE: Optional
				2/5-Tone Module,
				P.N. 585-7500-
				026, is required to
				utilize the two-
				tone feature.

Parameter		Description

Rx Freq	Sets the frequencies for the first and second tones from 250-3300 Hz. The closest tone is selected.
1st/2nd

Group Call	Programs if the 1st or 2nd tone is used for the group code.

Text	Programs the text that is displayed when a matched 2-tone is received. The characters and other information
	described for “TEXT” in Table 4-1also applies to this text.

Bell	Selects the bell indicator condition when receiving a matched 2-tone. The following conditions can be
	programmed:
	Null - The bell indicator condition is not changed, even when a matched code is received.
	Off - The bell indicator goes off.
	On - The bell indicator appears until a key is pressed.
	Blink - The bell indicator blinks until a key is pressed.

ANS	Turns the Answer Back function on and off. This function transmits a 1 kHz single tone for 2 seconds when
	receiving a matched 2-tone code.

EXO	“On” activates an external alert such as a horn or buzzer when a matching 2-tone code is received. The activa-
	tion time is set by “EXO Timer” in the Rx Code Common screen (see below). The optional accessory cable is
	required to utilize this feature.

				November 1998
	4-11		Part No. 001-7600-001