EFJohnson 761X Parameter, Rf Pwr, Lockout, Scan, Auto Reset, Tone, Log On/Off, November, Part No

PROGRAMMING

	Table 4-1 Memory Channel Screen Description (LMR Models) (Continued)
Parameter	Description
RF PWR	Programs the RF power output for the channel (High, Low1, Low2). This setting can be temporarily or perma-
	nently overridden by the HIGH, LOW1, or LOW2 power option switch if it is programmed (see Table 4-2).
Lockout	Transmit Disable On Busy. The following conditions can be programmed:
	Off - No restrictions; the transmitter can be keyed even while receiving a signal.
	Busy - Transmitting is inhibited if the channel is busy (carrier present).
	Repeater 1 - Transmission is permitted only when (1) receiving a signal on the programmed Call Guard tone or
	code (CTCSS/ DCTS) or (2) when no carrier is being detected.
	Repeater 2 - Transmission is permitted when (1) receiving any Call Guard tone or code (CTCSS/DCTS) or (2)
	when no carrier is being detected.
	NOTE: If an attempt is made to transmit in a lockout condition, transmitting is inhibited for the “Lockout
	Penalty Time” programmed on Common screen (see Table 4-7).
Scan	Assigns the channel to up to five scan lists and also programs if the scan list status can be changed by the scan
	list programming key (TAG). Press the spacebar to enter or delete all lists or press 1-5 to toggle the status of a
	list. Press the backspace key to toggle the inhibit status. Scan list programming is inhibited when parentheses
	are displayed around the numbers (or underline characters).
Auto Reset	If PWR ON Scan is enabled in the Scan screen (see Table 4-5), this selects the time delay before scanning
	resumes after a call is complete (the signal disappears) or a key is pressed. Either Timer A or Timer B can be
	selected. These timers are programmed in the Common Screen (see Table 4-7). Auto reset can be turned off by
	setting the timer to “Off” (0).
2-Tone	Enables 2-tone operation on the channel and specifies the 2-tone code used. The 2-tone codes are programmed
	in the 2-Tone Code Ch screen (see Table 4-6). This requires the optional 2/5-tone module.
Log On/Off	Specifies if the DTMF ID code is transmitted when the PTT switch is pressed and released. The DTMF code is
	specified on the Log/ID line of the DTMF Autodial screen (Table 4-3). In the Common screen, if “TOT Timer
	ID Out” is “Yes”, this ID is also transmitted just before the transmitter is disabled by the time-out timer. The
	following conditions can be programmed:
	OFF (blank) - No ID code is transmitted.
	Log In - The ID code is transmitted when the PTT switch is pressed.
	Log Off - The ID code is transmitted when the PTT switch is released.
	Both - The ID code is transmitted when the PTT switch is pressed and again when it is released.

November 1998
Part No. 001-7600-001	4-6