13 electrolux indoor unit installation
indoor unit installation electrolux 14
above 120mm from the wall
Refrigerant pipe hole (left) Ø 65
150mm del techo
|
| 998 |
|
| 380 | 380 | 119 |
293 |
|
| 41 |
130 |
| 130 | |
|
| ||
| 50 |
| 50 |
Indoor unit outline
above 120mm from the wall
Connective pipe and drainage installation
Drainage
1. Run the drain hose sloping downward. Do not install the drain hose as illustrated below.
2.When connecting extension drain hose, insulate the connecting part of extension drain hose with a shield pipe, do not let the drain hose slack.
Do not block water flow by a rise.
Do not put the end
of drain hose into water.
Do not block water flow by a rise.
Modelos 24000 Btu’s
Fixing the installation plate
1. | Install the installation plate |
| horizontally over the structural |
| parts on the wall using the spaces |
| indicated on the plate, as shown in |
| the figure above. |
2. | In the case of tiled, concrete or |
| similar walls, create 5 mm- |
Fit the Installation Plate and drill holes in the wall according to the wall structure and corresponding mounting points on the installation plate (Dimensions are in “mm” unless otherwise stated).
Connective pipe installation
1. | For the |
| piping, remove the pipe cover from |
| the side panel. |
2. | For the |
| hand piping, install the piping as |
| shown. Bend the connective pipe to |
Pipe cover | Pipe | Pipe cover |
(right) | holder | (left) |
diameter holes. Place anchorage |
supports for the appropriate |
be laid at 43mm height or less from |
the wall. |
Right piping
Right back piping
| assembly screws. |
3. | If expansion screws are used, the |
| holes must measure 11x20 or |
| 11x26, with a distance of 450 mm |
| between each. |
4. | Fix the installation plate to the wall. |
Placa de instalación
3. Fix the end of the connective pipe. | Indoor unit | Connective | |
outline | pipe | ||
|
43mm
Wall
Fastening the Indoor Unit
Drilling the Hole
1.Determine the position of the hole for the pipe using the installation plate and drill the pipe hole (ø 65mm) so that it is titled slightly downward.
2.Always use a pipe cover with an opening when drilling a metal bar.
Indoor unit
Outdoorunit
1.Pass the piping through the hole in the wall.
2.Put the upper claw at the back of the indoor unit on the upper hook of the installation plate, move the indoor unit from side to side to see that it is securely hooked (see Fig.10 & Fig.11).
Upper hook
Lower hook