Connectivity Module | 7000 & 4000 Series ATSs |
Device Configurator Screen for 7000 & 4000 Series ATSs
The Device Configurator Screen for 7000 & 4000 Series ATSs shows the Group 5 controller configuration settings (right side) and Connectivity Module (server) configuration settings (left side) for the selected ATS.
Group 5 Controller Configuration (right side)
Enter or change the ATS Name (8 char. max.)and the ATS Location (20 char. max.). Press the Update button when finished to save the controller configuration changes.
Connectivity Module (server) Configuration (left side)
Several configuration settings must be set appropriately as described below. Press the Update Server button when finished to save configuration changes.
Consult with your network administrator for these 4 settings:
IP Address
Subnet Mask
Gateway Address
TCP Port Number
(Range of ports allowed is:
ports
Serial Port Speed 19200
Flow Control No flow control
Interface Mode
Encyrption enable check box and assign an AES port (same range as TCP port but do not use the same port number used for TCP port.)
3rd party device running own protocols
SNMP refer to Appendix
ATS Name | ATS Location |
Press Update button when finished to save the configuration changes. Do this before you press Update Server button.
After Controller has been updated, press Update Server button to save the configuration changes.
Device Configurator Screen for 7000 & 4000 Series ATSs
When a Power Manager or Digital Power Meter is connected, additional buttons appear at the bottom of the Connectivity Module Device Configuration screen.
Press to configure the Power
Manager or Digital Power Meter.
Press to configure the Group 5 Controller.
After Controller, PM, or DPM has been updated, press Update Server button to save the configuration
Additional Buttons on Device Configurator Screen for
7000 & 4000 Series ATSs with Power Manager or Digital Power Meter
