Connectivity Module | Series 300 ATSs |
Device Configurator Screen for Series 300 ATSs
The Device Configurator Screen for Series 300 ATSs shows the Group 1 controller configuration settings (right side) and the Connectivity Module (server) configuration settings (left side) for the selected ATS.
Group 1 Controller Configuration (right side)
Enter or change the ATS Name (8 char. max.) and the ATS Location (20 char. max.). Press the Update button when finished to save the Group 1 controller configuration changes.
Connectivity Module (server) Configuration (left side)
Several configuration settings must be set appropriately as described below. Press the Update Server button when finished to save configuration changes.
Consult with your network administrator for these 4 settings:
IP Address
Subnet Mask
Gateway Address
TCP Port Number
(Range of ports allowed is:
ports
Serial Port Speed 9600 
Flow Control No flow control 
Interface Mode 
Encyrption enable check box and assign an AES port (same range as TCP port but do not use the same port number used for TCP port.)
ATS Name | ATS Location |
Press Update button when finished to save the configuration changes. Do this before you press Update Server button.
After Controller or has been updated, press Update Server button to save the configuration changes.
SNMP refer to Appendix
Device Configurator Screen for Series 300 ATSs
When a Power Manager or Digital Power Meter is connected, additional buttons appear at the bottom of the Connectivity Module Device Configuration screen.
Press to configure the Power Manager or Digital Power Meter.
Press to configure the Group 1 Controller.
After Controller, PM, or DPM has been updated, press Update Server button to save the configuration changes.
Additional Buttons on Device Configurator Screen for
Series 300 ATSs with Power Manager or Digital Power Meter
