Mounting the Access Point

Mounting on the Ceiling

To mount the Access Point 3000 on the ceiling, perform the following steps:

1.If you received washers with your kit, discard them.

2.Attach the mounting clips to the mounting bracket as shown below. Ensure that the screws line up with the holes on the tab of each side of the mounting bracket. Ensure that the nuts are secure, but do not tighten them.

3.Slide the mounting clips over the ceiling support, as shown below.

4.Tighten the bolts securely in place.

2-4 Hardware Installation

Page 28
Image 28
Enterasys Networks 3000 manual Mounting on the Ceiling