Using the CLI
Note: When using HyperTerminal with Microsoft® Windows® 2000, make sure that you have Windows 2000 Service Pack 2 or later installed. Windows 2000 Service Pack 2 fixes the problem of arrow keys not functioning in HyperTerminal’s VT100 emulation. See www.microsoft.com for information on Windows 2000 service packs.
4.Once you have set up the terminal correctly, press the Enter key to initiate the console connection. The console login screen will be displayed.
For a description of how to use the CLI and a list of all the CLI commands refer to the RoamAbout Access Point 3000 Configuration Guide.
Initial Configuration Using the CLI
To use the CLI to minimally configure the access point, perform the following steps:
1.Make a serial connection to the access point’s console port as described in the RoamAbout Access Point 3000 Hardware Installation Guide.
2.Use terminal emulation software to connect to the access point’s CLI.
3.Enter admin for the user name, and password for the password to log in. The access point 3000 CLI prompt appears.
Username: admin
Password:********
RoamAbout 3000#
4.Set the Country Code. This restricts operation of the access point to the radio channels permitted for wireless networks in the specified country.
a. Type country ? to display the list of countries.
RoamAbout 3000#country ?
WORD Country code:
AUSTRALIA,
CYPRUS,
PHILIPPINES,
