Enterasys Networks 6H302-48 manual Installation

3

Installation

ELECTRICAL HAZARD: Only qualified personnel should install the module.

NOTE: Read the Release Notes shipped with the module to check for any exceptions to the supported features and operation documented in this guide.

This chapter provides the instructions to install the 6H302-48 or 6H303-48 module. A Phillips screwdriver is required to install options into the module. Follow the order of the sections listed below to correctly install the module.

•Unpacking the Module (Section 3.1)

•Installing Options (Section 3.2)

•Installing the Module into the Matrix E7 Chassis (Section 3.3)

•Installing the Module into the SmartSwitch 6000 (6C105) Chassis (Section 3.4)

•Connecting to the Network (Section 3.5)

•Completing the Installation (Section 3.6)