ABOUT THIS SUPPLEMENT

This document is a supplement to the existing SmartSTACK Ethernet ELS10-27TX User Guide and should be used in conjunction with the SmartSTACK Ethernet ELS10-27TX User Guide. The information in this document describes the changes resulting from firmware revision 1.01.00.

This manual is for system administrators responsible for configuring, monitoring, and maintaining the SmartSTACK Ethernet ELS10-27TX (also referred to as ELS10-27). You should have a familiarity with networking concepts and principles. In addition, a basic understanding of SNMP is helpful.

The contents of each chapter are described below.

Chapter 1, Introduction, provides an overview of new VLAN and Workgroup functionality as well as additional functions for the SmartSTACK Ethernet ELS10-27TX.

Chapter 2, Configuring VLANs Using LCM, provides instructions on how to configure the SmartSTACK Ethernet ELS10-27TX VLAN functions using LCM.

Chapter 3, Configuring VLANs Using SNMP, provides instructions on how to configure the SmartSTACK Ethernet ELS10-27TX VLAN functions using SNMP.

Chapter 4, VLAN MIB Objects, provides a list of VLAN Configuration MIB Objects.

Chapter 5, Configuring Workgroups Using LCM, provides an overview of workgroup configurations and LCM commands.

Chapter 6, Configuring Workgroups Using SNMP, provides an overview of workgroup configurations and SNMP commands.

Chapter 7, Workgroup MIB Objects, provides a list of Workgroup MIB Objects used to configure Workgroups using SNMP.

Appendix A, Virtual LANs, describes how the switch uses VLANs to create isolated network domains, and provides illustrations of VLAN switch configurations.

xv

Page 17
Image 17
Enterasys Networks ELS10-27TX manual About this Supplement