Configuring VLANs Using SNMP
-The selected ports are removed from the list of ports in the table entry.
-If there are no ports left on the VLAN, and the VLAN ID does not equal 0x001, then the BPDU addresses and the MP MAC address is deleted from the address database.
-All APR entries are flushed from the ARP table.
-If there are no ports left on the VLAN, delete the IP address from the routing table and clear the table entry.
3.3THE CONFIG EGRESS LIST
The ConfigEgressList table is used to configure the default VLAN ID on specific ports. This is always a modify function, therefore, there is no need for the VlanConfigEstablish object.
The four parameters are index, VLAN ID, ports and status. For a list of Config Egress MIB, refer to Chapter 3, Configuring VLANs Using SNMP.
As in the config table, valid entries are between 0 and 31. An index outside of this range allows read/write access to the local variables.
You must do a read of the entire table to gain knowledge of current table configuration.
