Enterasys Networks ELS10-27TX manual Configuring Workgroups Using Snmp

Configuring Workgroups Using SNMP

If ports are added to an existing workgroup, the index into the workgroup table would be written to els10-27WorkGroupNumber. This would be obtained by first reading all of the entries in the workgroup table. The name of the workgroup you want to add ports to would be written to els10-27WorkGroupName.

If a workgroup was to be deleted, the index into the table and the workgroup name would be used, as in the previous example, any value should be written to els10-27WorkGroupPorts. However, a value of 4 would be written to els10- 27WorkGroupType to perform a delete.

NOTE

You must delete the Workgroup in its entirety. You cannot delete part of a Workgroup.

6-3