Bridge Configuration | Enterasys Networks ELS10-27TX instruction

CHAPTER 4

VLAN MIB OBJECTS

4.1 OVERVIEW

This chapter describes the MIB objects that relate to configuring 802.1Q VLANs. The MIB system groups described alphabetically in this chapter are as follows:

•Bridge Configuration

•Configuration Entries

•Device Entries

•Egress Table

•Filter GVRP

•Static MAC Address Entries

For procedures describing how to configure VLANs, refer to Chapter 3, Configuring VLANs Using SNMP.

4.2 BRIDGE CONFIGURATION

The els10-27VlanBridgeConfig group manages the overall configuration of the bridge’s VLAN resources.

The implementation of this group is MANDATORY.

The OBJECT-TYPE is from RFC-1212.

4.2.1 VLAN Version Number

Specifies the version of IEEE 802.1Q VLAN that has been implemented. A value of 1 will be returned.

els10-27VlanVersionNumber OBJECT-TYPE

SYNTAX INTEGER

ACCESS read-only

STATUS mandatory

::= { els10-27VlanBridgeConfig 1 }

The MIB OBJECT IDENTIFIER for accessing the VlanVersionNumber is:

OID 1.3.6.1.4.1.97.9.20.1

4-1

Image 51

Enterasys Networks ELS10-27TX manual Bridge Configuration, Vlan Version Number

Contents

SmartSTACK Ethernet ELS10-27TX Supplement Page Page FCC Notice Cabletron SYSTEMS, INC Program License Agreement Page Page Page Cabletron Systems Limited Program License Agreement Viii Page Declaration of Conformity Contents Vlan MIB Objects Configuring Vlans Using Snmp Xiii Appendix a Virtual Lans Vlans Index Configuring Workgroups Using LCMConfiguring Workgroups Using Snmp Workgroup MIB Objects About this Supplement Your email address Getting Help Document Conventions Document Title Part Number Related Documentation Product Overview Using Vlans on the ELS10-27TX Ieee 802.1Q Standard 802.1Q Mode on ELS10-27TX Vlan Hybrid Ports 802.1Q ModeVlan Access Ports 802.1Q Mode Preserving Priority 3 802.1Q Trunk Ports Non-Preserving Priority Accessing Network Management Using VLANs Switch Mode Default Port Vlan IDAssigning Ports to a Vlan Enable Gvrp Restricting VLANs 802.1Q Mode Workgroups Virtual Workgroups will only operate in 802.1D mode Installation and Management Default GatewayPage LCM Conventions Overview Subset of LCM Commands LCM Command Summary LCM Command Syntax Exit or Logout Basic LCM CommandsHelp Erase Enable Command Address Limit LCM Commands Route Command Port Command Port Command Enhancements to LCM Commands Switch Command Trap Control Command ELS10-27vlan add 5-9 blue Vlan CommandPage Config Table Configuring Vlans Using Snmp Overview Modifying, Creating and Deleting VLANs Step ActionModifying a Vlan Deleting a Vlan Creating a Vlan Config Egress List Modifying a Config Egress List Entry Modifying, Creating or Deleting a Filter Gvrp Table Entry Filter Gvrp Table Deleting a Filter Creating a Filter Static MAC Entry Creating a Static MAC EntryDeleting a Static MAC Entry Vlan Version Number Bridge Configuration Reset VlanReset Operating Mode VlanOperatingMode Syntax Octet String Size Gvrp Enable VlanGVRPEnable Vlan VlanConfigVlan Access List VlanAccessList Configuration Entries Entry VlanConfigEntryVlanConfigEntry VID VlanConfigVID Index VlanConfigIndex IP VlanConfigIP Ports VlanConfigPorts Name VlanConfigName IP Mask VlanConfigIPMask Establish VlanConfigEstablish Status VlanConfigStatus Static Configured VlanNumConfiguredEntries Device EntriesActive VlanNumActiveEntries Maximum Number VlanMaxNumEntries Configuration Table VlanConfigTable Egress Entry VlanConfigEgressEntry Egress Table Egress Table VlanConfigEgressTable Index VlanEgressIndex VlanConfigEgressEntry List VlanEgressList VID VlanEgressVID Status VlanEgressStatus Filter Gvrp Gvrp VlanFilterGVRPTableEntry VlanFilterGVRPEntry VlanFilterGVRPEntry VlanFilterGVRPIndex List VlanFilterGVRPList VID VlanFilterGVRPVID EstablishVID VlanFilterGVRPEstablishVID Status VlanFilterGVRPStatus Static MAC Address Entries Table VlanStaticTableEntry VlanStaticEntry VlanStaticEntry VID VlanStaticVID Port VlanStaticPort MAC VlanStaticMAC Establish VlanStaticEstablish Page Chapter Configuring Workgroups Using LCM Overview Workgroup Default Workgroup Configuration Examples Workgroup Superset Workgroups are only valid in 802.1D mode LCM Workgroup Commands ELS10-27workgroup omega Page Chapter Configuring Workgroups Using Snmp Overview Workgroup Configuration Procedures Configuring Workgroups Using Snmp Page Workgroups Using Snmp Chapter Workgroup MIB Objects OverviewNext Number WorkGroupNextNumber MAX Count WorkGroupMaxCount Current Count WorkGroupCurrentCount Table WorkGroupTable Entry WorkGroupEntry Name WorkGroupName Number WorkGroupNumber Type WorkGroupType Ports WorkGroupPorts Vlan Vlan Y Appendix a Virtual Lans Vlans Vlans and Frame Tagging Vlan ID ELS10-27TX Vlan Configuration Vlan Access Ports Ports in VlanVlan Egress Figure A-2. Vlan Access Ports Numerics Index Snmp Index