Enhancements to LCM Commands
2.5 LCM COMMANDS
The following is a list of commands that were modified for this release:
•Enable Command
•Route Command
•Port Command
•Switch Command
•Trap Control Command
•VLAN Command
Commands are listed alphabetically in this chapter.
2.5.1 Enable Command (Address Limit)
The address limit parameter was added to the enable command. If you set a limit on a port, the number of end user devices that can have connectivity will be limited. This is done by limiting the number of MAC addresses that can be learned on that port.
The format is:
enable
The default is “no limit” to the number of addresses that can be learned on a port. If you set the limit to zero, you allow unlimited access. If you enable a port without specifying an address limit, you remove the limit that was in effect.