54 Setting Up Network Projection
optional USB key—or configure your projector and network. Finally,
see the EasyMP Operation Guide for instructions on installing the
EMP NS Connection software and use it to project over the network.
Using Quick Wireless Connection
If you purchased the optional USB key, you can quickly connect the
projector to a Windows computer without any configuration.
First, make sure you have installed the wireless module and turned on
the projector as described on the Quick Setup sheet.
1. Connect the USB key to the projector’s Type A (flat) USB
port.
2. When you see a projected message that the network information
update is complete, remove the USB key.
3. Connect the USB key to a USB port on your computer or
notebook.
In Windows Vista, if you see the AutoPlay window, select
Run LaunchU3.exe. When you see the User Account Control
screen, click Allow.
4. When you see a license agreement, click Agree to install the
Quick Wireless Connection driver.
If you see a Windows Firewall message, click Yes to disable the
firewall.
After a few minutes, your computer image will be displayed
through the projector. If not, try restarting your computer.
note
Do not attempt to write to
the USB key or use it as a
flash memory drive.
note
The Quick Wireless
Connection utility will
disable any other wireless
sessions and adapter
programs. Make sure you
leave the USB key in your
computer for your entire
Quick Wireless Connection
session. Follow the
instructions on this page to
remove the USB key when
you are finished with the
session.