94 Setting Up Network Projection
4. Enter up to two IP addresses for notification.
You can enter a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used: 127.x.x.x,
224.0.0.0 to 255.255.255.255 (where x is a number from 0 to
255).
5. If your network environment uses an AMX controller, select ON
to allow the projector to be detected by AMX Device Discovery.
Connecting With Windows Vista
If you’re using Windows Vista and you installed the optional wireless
module (as described on the Quick Setup sheet), you can use the
Network Projector function to connect to the projector without
installing the EasyMP software. This provides a quick, easy way to
connect wirelessly, though with limited capabilities. Not all the
features available with EMP NS Connection are possible when
connecting using the Vista network projector function. All
performances are enhanced when you use EMP NS Connection.
Follow these steps:
1. Turn on the projector.
2. Press the EasyMP button on the remote control. The standby
screen appears.
note
Use only the Epson
802.11a/b/g wireless module
in the projector. If you see a
message asking you to insert
a LAN or memory card,
check to make sure your
802.11a/b/g module is
properly inserted (see the
Quick Setup sheet).