Setting Up Network Projection 65
Highlight the SSID text box, press Enter, and enter a name:
Use the buttons to select individual letters; then press Enter
to input a character. To add a blank space or to navigate backward
and forward through the input text, highlight the arrows and
press Enter. To toggle symbol settings or capital letters, highlight
the option and press Enter. When you’re done, highlight Finish
and press Enter.
Note that the SSID is case-sensitive (if you enter the name in
uppercase on the projector, you must type it the same way on the
computer connecting to the projector).
7. If your access point assigns IP addresses automatically, turn on
DHCP. Otherwise, turn off DHCP and enter the following
information:
■IP address: Enter the IP address you want to assign to the
projector. It must be formatted like other addresses on the
network. The last 3 digits should be unique.
■Subnet mask: For example: 255.255.255.000, but this
depends on how your network is set up.
■Gateway address: Enter the IP address that was assigned to
the access point or AirPort base station when it was set up.
8. If you want to prevent the SSID from being displayed on the
standby screen, set the SSID Display option to Off.
9. To prevent the IP address from appearing on the standby screen,
set the IP Address Display setting to Off.
10. When you’re done making these settings, highlight the Return
button at the top of the screen, then press Enter. Choose Setup
Complete and press Enter, then choose Yes and press Enter to
save your settings.
note
For specific details about
your network, please consult
your network administrator.
If you don’t know your
gateway or access point
address, see page71. If
you’re using AirPort, start
the AirPort Admin utility,
select your base station and
click Configure. Then click
the Network tab to see your
base station’s IP address.