90 Setting Up Network Projection
Connecting to a Wired Network
With the optional wired LAN module, you can connect the projector
to your network and configure it with an IP address. This provides an
alternative to connecting to the projector wirelessly.
1. If the optional wireless module is installed in the projector,
remove it as described on page 89. Then insert the wired LAN
module into the projector and replace the cover plate.
2. Connect the projector to your network using a commercially
available 100BaseTX or 10BaseT network cable. Connect the
cable to the LAN port on the projector.
3. Point the remote control at the projector and press the PPower
button.
4. Press the EasyMP button on the remote control to select EasyMP
as the source.
5. Press the Menu button on the remote control, select the
Network menu, then press Enter.
6. Choose Network Configuration and press Enter.
7. Choose Wired LAN and press Enter. You see the following
screen:
note
Only the Epson Ethernet
adapter is guaranteed to
work. Other brands may not
be compatible.
If you see a message asking
you to insert a LAN or
memory card, check to make
sure your Ethernet adapter is
p
roperly inserted.