3.Press the P Power button on the remote control or on top of the projector.

The projector beeps once and the Power light flashes green as the projector warms up, then an image begins to appear. When the Power light stops flashing and remains green, the projector is ready for use.

4. If you are prompted to enter a password, see page 129.

Using the Direct Power On Function

The Direct Power On function enables faster setup. The projector starts up automatically when you plug it in or turn it on with a wall switch. You don’t have to press the P Power button.

Follow these steps to enable Direct Power On:

1.Press the Menu button on the remote control or projector and select the Extended menu.

2.Choose Operation and press Enter.

3.Choose Direct Power On and press Enter.

warning

Never look into the lens when the lamp is on. This can damage your eyes, and is especially dangerous for children.

4.Highlight On and press Enter.

5.Press Menu to exit. The setting will take effect the next time you plug in the projector.

note

If a power outage occurs when Direct Power On is enabled and the projector is plugged in, the projector will start when the power is restored.

Displaying and Adjusting the Image 19