You see a projected message:

2.Aim the projector so the message appears near the middle of the screen. Then use the zoom ring to enlarge the image so the white frame (not shown above) extends beyond the edges of the screen on all sides.

3.Press the Quick Setup button again. Two white boxes flash momentarily onto the screen, and the adjustment is complete. Your projected image now fits on the screen (some slight overlap is normal).

The Quick Setup adjustment is retained when the projector is turned off. If the projector is installed in a fixed location, you won’t need to repeat the adjustment each time you turn it on. To fine-tune the Quick Setup adjustment, use Quick Corner® (below).

Using Quick Corner

Use Quick Corner to adjust the shape and size of the image when it’s uneven on all sides, or to finely adjust the image after performing Quick Setup. If you just used Quick Setup, you can use the projector’s arrow buttons to make the Quick Corner adjustment. If not, you’ll have to select Quick Corner as follows:

1.Press the Menu button on the remote control or on the projector’s control panel.

2.Select the Settings menu and press Enter.

3.From the Settings menu, select Keystone and press Enter.

4.Select Quick Corner and press Enter.

note

If Quick Setup did not detect the edges of your screen (for example, if you’re projecting on a wall), then the arrow buttons will be in Keystone correction mode after performing Quick Setup (see page 26).

Displaying and Adjusting the Image 25