Epson 1815p and, Select, Properties, IP address, Subnet mask, Default gateway, Internet Protocol, . Otherwise select, 11.When you’re done, click OK

note

For specific details about your network, please consult your network administrator.

note

If you don’t know your gateway or access point address, see page 72.

9.Select Internet Protocol and click the Properties button. You see this screen:

10.If your access point uses DHCP, select Obtain an IP address automatically. Otherwise select Use the following IP address and Use the following DNS server addresses, then enter the required information:

■IP address: Type in the IP address you want to assign to the computer. It must be formatted like other addresses on the network. The last section must be unique.

■Subnet mask: For example: 255.255.255.000, but this depends on how your network is set up.

■Default gateway: Enter the IP address that was assigned to the access point when it was set up.

■Preferred DNS server/Alternate DNS server: Enter the IP address of the DNS server(s) for your network.

11.When you’re done, click OK.12.Click the Wireless Networks tab.

(If you don’t see this tab, you may need to enable your wireless card or adapter by clicking Configure to access the device

70Presenting Through a Wireless Network