Epson 810, 820, 830 Figure 4-33.HP/PE sensor removal, Figure 4-35.HP/PE sensor cable placing position, Figure 4-34.Torsion spring 0.22 for each detection lever

EPSON Stylus PHOTO 810/820/830 Revision B

10.Remove the Spur gear 35.2 from the LD roller shaft.

11.Remove the Compression spring, 0.143, and remove the Clutch from the LD roller shaft.

12.Release one hook for securing the HP/PE sensor, and push the HP/PE sensor from the side contacting the Main frame by using the tweezers.

HP/PE sensor

Hook

Figure 4-33. HP/PE sensor removal

13.Remove the Torsion spring 0.22 for the HP/PE detection levers, and remove the these levers from the LD roller shaft holder.

†When assembling the HP/PE detection lever to the LD roller shaft holder,

„Make sure to set the Torsion spring 0.22 for the HP/PE detection levers to the following suitable position.

HP detection lever

Torsion spring 0.22

PE detection lever

Torsion spring 0.22

Figure 4-34. Torsion spring 0.22 for each detection lever„Make sure that the HP/PE detection lever moves smoothly.†When assembling the HP/PE sensor to the LD roller shaft holder,

„Make sure that the HP/PE sensor is correctly fixed by the hook of the LD roller shaft holder.

„Make sure to place the HP/PE sensor cable to the suitable groove on the LD roller shaft holder.

	.
HP/PE sensor cable		HP/PE sensor cable

HP/PE sensor

Figure 4-35. HP/PE sensor cable placing position

Disassembly and Assembly Disassembly 108