Epson 83 f t Power indicator lights red, Cause, Status, Problem, Problem Solving, Remedy or Status, If it is cracked, If it is not cracked, If the error continues

Problem Solving 39

f t Power indicator lights red				Problem
						: Lit	: Flashing:	: Off
	Status		Cause			Remedy or Status
		Red	Internal Error		Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or the nearest
					address provided in the International Warranty Terms. sInquiries
		Red
		Red
		Red	Fan Error		Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or the nearest
			Sensor Error		address provided in the International Warranty Terms. sInquiries
		Red
		Red	High Temp Error		The lamp turns off automatically and projection stops. Wait for about five minutes. After about five minutes the projector
			(overheating)		switches to standby mode, so check the following two points.
					• Check that the air filter and air exhaust vent are clear, and that the projector is not positioned against a wall.
		Red			• If the air filter is clogged, clean or replace it. s p.50, 56
					If the error continues after checking the points above, stop using the projector, disconnect the power cable from the
					electrical outlet, and contact your local dealer or the nearest address provided in the International Warranty Terms.
					sInquiries
					When using at an altitude of 1500 m or more, set "High Altitude Mode" to "On". s p.30
		Red	Lamp Error		Check the following two points.
			Lamp Failure		• Take out the lamp and check if it is cracked. s p.53
		Red	Lamp Cover Open		• Clean the air filter. s p.50
					If it is not cracked - Re-fit the lamp and turn on the power.
					If the error continues - Replace the lamp with a new lamp and turn on the power.
					If the error continues - Stop using the projector, disconnect the power cable from the electrical outlet, and contact
						your local dealer or the nearest address provided in the International Warranty Terms.
						sInquiries
					If it is cracked - Replace it with a new lamp, or contact your local dealer for further advice. If replacing the lamp
					yourself, be careful to avoid pieces of broken glass (you cannot continue projecting until the lamp is replaced). sInquiries

Check that the lamp cover and the lamp are securely installed. s p.53

If the lamp cover or the lamp is not securely installed, the lamp does not switch on.

When using at an altitude of 1500 m or more, set "High Altitude Mode" to "On". s p.30