Problem Solving | 46 |
|
|
f Problems when projection starts
f Power does not turn on |
|
|
|
Check | Remedy |
Did you press the [Power] button? | Press the [Power] button to turn the power on. |
|
|
Are the indicators switched off? | The power cable is not connected correctly or power is not being supplied normally. |
| Connect the projector's power cable correctly. s Quick Start Guide |
| Check that your electrical outlet or power source is functioning correctly. |
|
|
Do the indicators turn on and off when the power cable is | There is probably a poor contact in the power cable, or the power cable may be defective. Reinsert the power |
touched? | cable. If this does not solve the problem, stop using the projector, disconnect the power cable from the |
| electrical outlet, and contact your local dealer or the nearest address provided in the International Warranty |
| Terms. sInquiries |
|
|
Is the operation lock set to "Full Lock"? | When you press and hold down the [Enter] button on the control panel for about seven seconds, a message is |
| |
|
|
Is the correct setting for the remote receiver selected? | Check the "Remote Receiver" in the configuration menu. |
| |
|
|
Was the power cable plugged back in immediately after | When the operation to the left is performed when "Direct Power On" is set to "On", the power may not turn |
Direct Power Off, or is the breaker turned off? | back on. Press the [Power] button to turn the power back on. |
| |
|
|
fOther problems
f There is no audio or the audio is too low
Check | Remedy |
Is the audio source connected correctly? | Check that the cable is connected to the Audio port. |
|
|
Is the volume adjusted to the minimum setting? | Adjust the volume so that sound can be heard. s Quick Start Guide |
|
|
Is A/V Mute active? | Press the [A/V Mute] button on the remote control to cancel A/V Mute. s p.15 |
|
|
Is the audio cable's specification "No resistance"? | When using a commercially available audio cable, make sure it is labelled "No resistance". |
|
|