Replacing Consumables
fHow to replace the lamp
Warning
•When replacing the lamp because it has stopped illuminating, there is a possibility that the lamp may be broken.
If replacing the lamp of a projector which has been installed on the ceiling, you should always assume that the lamp is broken, and you should stand to the side of the lamp cover, not underneath it. Remove the lamp cover gently. Small pieces of glass may fall out when the lamp cover is opened. If pieces of glass get into your eyes or mouth, seek medical advice immediately.
Caution
•When replacing the lamp because it has stopped illuminating, there is a possibility that the lamp may be broken.
Wait until the lamp has cooled down sufficiently before removing the lamp cover. If the lamp is still hot, burns or other injuries may result. It takes about one hour after the power has been turned off for the lamp to be cool enough.
53
Procedure
A After you turn off the projector's power and the confirmation buzzer beeps twice, disconnect the power cable.
B Wait until the lamp has cooled down, then remove the lamp cover.
Loosen the lamp cover fixing screw with the screwdriver supplied with the new lamp or a + head screwdriver. Then slide the lamp cover straight forward and lift it to remove.