77
MaintenanceMaintenance
PROCEDURE
Turn off the projector power, wait for the cool-down
period to end, and then disconnect the power cable.
The cool-down period lasts for about 20 seconds.
Wait until the lamp has cooled down, and then
remove the lamp cover from the base of the projector.
It takes approximately one hour for the lamp to cool down by
itself after the cool-down period has finished.
Insert the screwdriver that is supplied with the spare lamp or a
flat-tipped screwdriver into the gap in between the projector
and the lamp cover, and slide the screwdriver in until the [ ]
mark on the lamp cover and the [ ] mark on the projector are
aligned. Then lift up the lamp cover to remove it.
Loosen the two lamp fixing screws.
Use the screwdriver that is supplied with the spare lamp or a
flat-tipped screwdriver to loosen the two silver lamp fixing
screws that are securing the lamp to the projector.
Replacing the Lamp
CAUTION
Wait until the lamp has cooled down sufficiently before removing the
lamp cover. It takes a further one hour after the cool-down period
has finished for the lamp to be cool enough.
1
2
1
2
3