78
MaintenanceMaintenance
Take out the lamp.
Hold the lamp as shown in the illustration below and lift it up
and out of the projector.
If the lamp is broken replace by a new lamp, or contact your
local dealer for further advise. If replacing the lamp yourself, be
careful to avoid pieces of broken glass.
Install the new lamp.
Hold the lamp so that it faces the correct way to fit into the
projector, and then insert the lamp until it clicks into place and
tighten the two fixing screws.
Install the lamp cover.
Insert the two cover tabs into the projector until the [ ] mark
on the lamp cover is aligned with the [ ] mark on the projector,
and then slide the lamp cover in until it clicks into place.
4
5
6
1
2Insert the cover so that
the [ ] mark and the
[ ] mark are aligned.
TIP
• Install the lamp securely. If the lamp cover is removed, the lamp
turns off automatically as a safety precaution. Moreover, the lamp
will not turn on if the lamp or the lamp cover is not installed
correctly.
• Spare lamps are provided with a spare air filter. The air filter should
also be replaced when the lamp is replaced. p.80
• Dispose of used lamps properly in accordance with your local
regulations.