Using the Serial Interface

If you have a printer or other peripheral device that uses a serial interface, connect it to the serial interface labeled RS-232C on the right side of the computer.

serial pot-l

The Equity LT-286e uses an IBM PC AT-compatible, 9-pin, D-shaped male connector, so be sure you have a compatible cable or an adapting cable that converts the 9-pin output to the standard 25-pin output. To connect a serial device, follow the steps above for connecting a parallel device.

Make sure the serial port is set up to function properly. If you are using the port for a serial printer, you must also redirect printer output from the parallel port to the serial port. Use the MS-DOS MODE command (or the Epson MENU program) to make these changes. See your MS-DOS Reference Manual for instructions.

The standard DIP switch settings for the LT-286e define your serial port as the primary serial port. If you think the DIP switch settings have been changed or you would like a different setting, see “Setting the DIP Switches” in Appendix A.

Setting Up Your System

1-9