4. Operation
18 OP1 Rev.1a
If the Operator Panel is set as a control device, buttons for executing and stopping programs
are displayed on the Program Execution screen to enable these operations.
Program Execution screen (when operations from the Operator Panel are
available)
(16) Cancel program(14) Execute program (15) Pause program
(13) Select program No
(17) Reset
(13) Select program No.
This button is for selecting the number of the program to execute. Each touch of the
<←> or <→> buttons decrements or increments the currently displayed program
number. You can also directly input program numbers by touching the program
number.
(14) Execute program
This button is for executing the program. Touching this button starts execution of the
currently selected program.
This button also functions as the button for resuming execution of a paused program.
When you execute or resume program execution, a confirmation dialog box is
displayed.
(15) Pause program
This button is for pausing the currently executing program.
Resume execution of a paused program → Execute program button
Cancel a program → Cancel program button
(16) Cancel program
This button is for cancelling the currently executing program.
(17) Reset
This button is for resetting Emergency Stop state or Error state.
I/O output can also be reset. However, I/O output reset is not available at the
shipment setting from the manufacturer.
For details, refer to EPSON RC+ 5.0 User's Guide 5.12.2 Controller Command
(Setup Menu)-Preferences Page.