Security functions

C Turn “Password Timer” on.

If you don't use this setting, proceed to step 4.

(1)Select “Password Timer,” and then press the [Enter] button.

(2)Select “ON,” and then press the [Enter] button.

(3)Press the [Esc] button.

(4)Select “Timer” and then press the [Enter] button.

(5)While holding down the [Num] button, use the numeric keypad buttons to enter the setting time within the range of 1 to 9999 hours and then press the [Enter] button.

If you make a mistake entering the time, press the [Esc] button and re-enter the time.

When you have finished using the “Password Protect” menu, the countdown for the elapsed time will start.

D Turn “User’s Logo Protect” on.

(1)Select “User’s Logo Protect,” and then press the [Enter] button.

(2)Select “ON,” and then press the [Enter] button.

(3)Press the [Esc] button.

30

E Enter the password.

(1)To set a password, select “Password” and then press the [Enter] button.

(2)The message “Change the password?” will be displayed, so select “Yes” and then press the [Enter] button. The default setting for the password is “0000,” but you should change this to your own desired password. If you select “No,” the screen shown at step 1 will be displayed again.

(3)While holding down the [Num] button, use the numeric keypad buttons to enter a 4-digit number. The number entered will be displayed as “* * * *.” Once four digits have been entered, the confirmation screen will be displayed.

(4)Re-enter the password.

The message “The new password is stored.” will be displayed. If you enter the password incorrectly, a message will be displayed prompting you to re-enter the password.