| Problem Solving | 52 |
| ||
|
|
|
Image is too large and cut off, or too small
| Check | Remedy | |
|
|
|
|
Has the “Aspect ratiog” been set | Press the [Resize] button on the remote control. sp.23 | ||
correctly? |
| ||
|
|
|
|
Is the image still being enlarged by the | Press the [Esc] button on the remote control to cancel the | ||
| |||
|
|
|
|
Has the “Position” setting been adjusted | If analog RGB images from a computer or RGB video images are being projected, press the [Auto] | ||
correctly? | button on the remote control or the [Enter] button on the projector’s control panel to carry out automatic | ||
|
|
| adjustment. |
|
|
| If the images have not been correctly adjusted after using the automatic setup function, adjust the setting |
|
|
| manually using the “Position” menu command. |
|
|
| If signals other than analogue RGB images from a computer or RGB video images are being input, adjust |
|
|
| the setting manually using the “Position” menu command. “Signal” - “Position” sp.36 |
|
|
|
|
Has the computer been set for dual | If dual display has been activated in the Display Properties of the computer’s Control Panel, the projector | ||
display? | will only project about half of the image on the computer screen. To display the whole of the image on | ||
|
|
| the computer screen, turn off the dual display setting. (See your computer video driver documentation) |
| Only when projecting computer images |
| |
|
|
| |
|
|
|
|
|
|
|
|
Has the correct resolution been selected? | Set the computer so that the signals that are output are compatible with this projector. | ||
|
|
| “List of Supported Monitor Displays” sp.73 (See your computer documentation) |
| Only when projecting computer images |
| |
|
|
| |
|
|
|
|