| Problem Solving | 49 |
| ||
|
|
|
Problems relating to images
No images appear
|
| Check | Remedy | ||
|
|
|
|
|
|
Was the [Power] button pressed? | Press the [Power] button to turn the power on. | ||||
|
|
|
|
|
|
Are both indicators switched off? | The power cable is not connected correctly or power is not being supplied normally. Connect the | ||||
|
|
|
|
| projector’s power cable correctly. (See the Quick Setup sheet) |
|
|
|
|
| Check that your power supply socket is working. |
|
|
|
|
|
|
Is A/V Mute mode active? | Press the [A/V Mute] button on the remote control to cancel the mute. sp.22 | ||||
|
|
|
|
|
|
Have the configuration menu settings | Reset all of the settings. “Reset” - “Reset All” sp.41 | ||||
been made correctly? |
| ||||
|
|
|
|
|
|
Is the projected image completely black? | Some input images, such as screen savers, may be completely black. | ||||
|
|
|
|
| |
| Only when projecting computer images |
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
Are the image signal format settings | If a composite videog or | ||||
correct? | command to select the signal format. “Signal” - “Video Signal” sp.36 | ||||
|
|
|
| ||
|
| Only when projecting images |
|
| |
|
| from a video source |
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
Projection stops automatically
Check | Remedy |
|
|
Is "Sleep Mode" set to "ON"?When the “Sleep Mode” menu command has been set to “ON,” the lamp turns off automatically if no buttons are pressed for about 30 minutes while no video signal is being input. The Power indicator is lit orange at this time. Press the [Power] button to turn the power on. If you do not want sleep mode to be used, change the “Sleep Mode” setting to “OFF.” “Extended” - “Operation” - “Sleep Mode” sp.39