Epson SEIJ98006 Printer Mechanism Removal, P O I properly as shown in Figure, EPSON Stylus Color

EPSON Stylus Color 900

4.2.2 Printer Mechanism Removal

1.Remove the upper case. (See Section 4.2.1.)

2.Unlock the cable clamp on the relay board, then take all harnesses out of the cable holder.

Screws securing the

Printer Mechanism

Cable Holder

Relay Board

Screws securing the

Waste Ink Drain PadsScrew securing the Printer Mechanism

Revision C

C H E When assembling, be sure to connect the connectors

PO I properly as shown in Figure 4-5.

19-pin FFC (used to supply sensors with power and to send condition detection signals)

2-pin connector for driving the solenoid Connector for ASF

Connector for PF motor Connector for Pump/ASF motor Connector for PE sensor

￿Connector for CR motor

Connector for CRHP (Carriage Home Position) sensor

C R H P S e n s o r C R M o t o r

P u m p / A S F M o t o r

M / C
R E	W	M	P F M o t o r
D	H	/	f r o m C N 1 1 o n t
C RH	T	B LK C	f r o m C N 1 2	o n t
			f r o m C N 1 0	o n t
P E			f r o m C N 1 6	o n t

Printhead FFCs

Figure 4-4. Printer Mechanism Removal

3. Disconcert the following connectors from the relay board. (The

AS F A S

P E

M		S o l e n o i d
/	f r o m C N 1 5 o n t h
C

f r o m t h e c o n t r o l p

FS e n s o r S e n s o r

connectors to be disconnected are colored red in Figure 4-5.)

Figure 4-5. Connector Location

Disassembly and Assembly Disassembly Procedures 107