Epson SEIJ98006 manual Adjustment Adjustments 145

EPSON Stylus Color 900 Revision C

16. The following screen appears.						NOTE:
						During the step 12 onward, the printhead is left away from the
						capping position. Therefore, please make this adjustment as fast as
						possible to prevent the printhead surface from drying. Otherwise,
	I n	c a s e	o f 1 s t p r in t :			you will spend extra time on solving the print problem as a result.
	1 . A f t e r y o u h a v e m o v				e d t h e a n g u la r a d ju s t m e n t le v e r ,
	2 . p u s h t h e c o lo r I / C				f r o m f r o n t s id e b y u s in g f in e d r iv e r o r t w e e z e r s .
						18. Press the Enter key in the screen (Figure 5-25).
	3 . P le a s e g e n t ly t ig h t e n t h e s c r e w s t h e r ig h t s id e a t f ir s t ,									a n d p r e s s
		t h e E n t e r k e y .
	4 .	T h e	h e a d a n g u la r a d ju s t m e n t			p a t t e r n w ill		b e p r in t e d .
						19. The printer runs the Head Angular Adjustment Pattern. The
						following screen appears.
				E n t e r : O K
Figure 5-25. Prompt to Move the Angular Adjustment Lever
17-1. At first, set the angular lever to the center position. (As the
center value is marked with the protrusion, it can be easily									R e - A d j u s t m e n t
									E n d
found.)
17-2. Push the color I/C from the front side to eliminate tolerance by
							D o	n o t e je c t a p a p e r
using a fine driver of tweezers.							A n d s e le c t o u t t h e b
17-3. Gently tighten the right side screw at first, then gently tighten the							E s c : U p / D o w n a r
left side screw.
						Figure 5-27. Prompt to Move the Angular Adjustment Lever
		A n g u la r L e v e r C e n t e r p o s it io n
						20. Select “Re-Adjustment” in the screen (Figure 5-27).

Figure 5-26. Setup for the Head Angular Adjustment Lever

Adjustment Adjustments 145