Epson SEIJ98006 14. Head Angular Adjustment Initial Screen, 13. Adjustment 2 Selection Screen

EPSON Stylus Color 900							Revision C
5.2.4 Head Angular Adjustment		3. Select “Head Angular Adjustment”. The following screen appears.
This section describes how to adjust the head angular. This adjustment
must be made under the following conditions:				H e a d A n g u la r A d
1.	The printhead has been removed. (When the printhead has
				P r in t t h e h e a	d	a n g
	been replaced.)			H e a d a n g u la r	a d ju
2.	The head angular adjustment lever has been moved. (Be sure
	to release two screws securing the head fixing plate before
	moving the lever. Failure to do so may damage the lever.)
3.	CR Guide Shaft has been lubricated. (Notice you are required		E s c : P r e v io u s			U p /
	to remove the printhead before lubricating the CR guide shaft in
	this printer. Refer to Chapter 6 “Maintenance”.)
4.	CR guide shaft has been removed.	Figure 5-14. Head Angular Adjustment Initial Screen
NOTE:		4. Select “Print the head angular adjustment pattern” to check the
Be sure to use Super Fine paper for Head Angular Adjustment.		current head angular condition.
1. Referring to Section 5.2.1, perform the preliminary operation.		5. The following screen appears and the printer starts running Head
		Angular Adjustment Pattern.

2.In the main adjustment menu, select “Adjustment 2”. The following screen appears.

* * * * * * * * * * 9 E0 P0 S SOENR VS ItCy luE sP* *RC*OO*G*LR*O*ARM V e r s io n 1 . 2 * * *

T h e H e a d A n gillula br eA dp

< < A d ju s t m e n t 2 > >

H e a d A n g u la r A d

B i - D ir e c t io n a l A

E S C : Q u it U p / D o w n a r r o w s : S e le c t E

	Figure 5-15.
Figure 5-13. Adjustment 2 Selection Screen	Screen during the Head Angular Adjustment Pattern Print

Adjustment Adjustments 141