Epson SEIJ98006 manual Head Actuator Voltage Input, 7. Head ID Input / Check Selection Screen

EPSON Stylus Color 900 Revision C

5.2.3 Head Actuator Voltage Input

This section describes how to input Head ID. Perform this operation under the following conditions:

1.The printhead has been replaced.

2.The C265 Main board has been replaced.

3.When the ROM (version TEE012A, 01B, or 01C) is replaced with the revised one (TEE01D or newer).

NOTE:￿

After replacing the printhead, be sure to install a new ink cartridge in the I/C replacement sequence before inputting the

￿Head ID.

After replacing the printhead, if you install the I/C before turning on the printer, the next power on may cause the Head Hot Error (Panel Indication = Ink Out Error), and the printer loses all controls by the PC in that error condition.

1.Before replacing the printhead or main board, make a note of a 22- digit head ID.

2.Referring to Section 5.2.1, perform the preliminary operation.

3.Select “Adjustment 1” and then “Head Actuator Voltage ID Input”.

4.The following screen appears.

R e a d in g o u t t h e p r

M a r k e t D e s t in a t io

E s c : P r e v io u s

Figure 5-7. Head ID Input / Check Selection Screen

5. Select “Input data”.

H e a d A c t u a t o r V o

		C h e c k	p r e s e n t
		I n p u t d a t a
T h e r e i s a p o s s i b i l i t y t h a t y o					u
p r o c e d u r e f o r r e p l a c i n g t h e p r
w h e n y o u r e i n s t a l l a b r a n d - n e w
1 .	W r i t e d o w n t h e n e w h e a d I D
2 .	T u r n o n t h e p r i n t e r . ( I / C o
3 .	I n s t a l l t h e b r a n d - n e w I / C b
4 .	I n p u t t h e h e a d I D w r i t t e n o
	a u t o m a t i c a l l y r e t u r n t o t h e
5 .	C o n t i n u e t o t h e h e a d a d j u s
	* * * * * * D o n 't i n s t a l l a b r a n d
	E s c : P r e v io u s			U p /

Figure 5-8. Head ID Input Screen

Adjustment Adjustments 137