Epson SEIJ98006 Shield Plate on the C265 Main Board Removal, 8. Shield Plate Removal, Revision C

EPSON Stylus Color 900 Revision C

4.2.5 Shield Plate on the C265 Main Board Removal

1.Remove the C265 Main board. (See Section 4.2.3.)

2.Remove the remaining four connectors from the relay board. (See Figure 4-5 when connecting them.)

3.Remove two screws securing the right upper main shield plate to the bottom frame and another two screws securing the left upper main shield plate to the bottom frame, then remove the both plates together.

4.	Disconnect the FFC from the connector CN15 on the C265 Main
	board.
5.	Remove two screws securing the shield plate (top) to the bottom
	frame, and remove the shield plate (top).
6.	Remove the Type-B interface guide.
7.	Remove four screws securing the C265 Main board onto the bottom
	frame. (Two screws among the four are fixing the reinforcing plate
	for the Type-B interface guide.)

Screws securing the Shield Plate (top)

Screws securing the

Right Upper Main Shield Plate

8. Viewing the C265 Main board from the Centronics I/F connector

side, remove four small screws and remove the C265 Main board.

Screws securing the

Left Upper Main Shield Plate

Shield Plate (top)

CN15

Right Upper MainShield Plate

Type B I/F Guide

Left Upper Main Shield Plate

Figure 4-8. Shield Plate Removal (1)

Screws securing the C265 Main Board

Figure 4-9. Shield Plate Removal (2)

Disassembly and Assembly Disassembly Procedures 110