Epson SEIJ98006 22. Special Setting Mode, EPSON Stylus Color, Revision C, Product Description

EPSON Stylus Color 900 Revision C

￿Printhead alignment mode Alignment method is as described below:

1.While holding down both Load/Eject and Cleaning (Black) buttons, turn the printer on.

2.Printer prints an instruction sheet that shows how to adjust the printer and current alignment.

3.Referring to the current alignment, press the Cleaning button until the LED indicate the appropriate test number.

4.Press the Load/Eject button. The printer prints the test pattern.

5.Referring to the test patterns on the new printout, select the most closely aligned pattern by pressing the Load/Eject button.

6.Press the Cleaning button.

7.Repeat the steps from 3 to 6 until all test patterns are properly aligned.

8.Turn the printer off.

1.4.2.2 Special Setting Mode

While turning the printer on, pressing the both Load/Eject and Cleaning buttons generates the Special setting mode. While the Paper Out LED is blinking, activate each function by pressing the specified button(s) in the method described in Table 1-22.

Table 1-22. Special Setting Mode

Switch	Function
	While the Paper Out LED is blinking, pressing
Load/Eject	the Load/Eject button initializes the EEPROM
	and resets the timer IC. (Refer to EEPROM
	Address Map in Appendix.)
	While the Paper Out LED is blinking, pressing
Cleaning	the Cleaning button for 10 seconds resets the
(Hold it down for 10 seconds)	waste ink counter in the EEPROM. (Refer to
	EEPROM Address Map in Appendix.)

Product Description Control Panel Operation 34