Equator 375 service manual Ditrubance, Trouble-shooting, Cause, Remedy

Ditrubance	Cause	Trouble-shooting	Remedy
		Check if blade is locked	Fittings for fan or air
		mechanically.	guiding duct are adjusted
No-Frost			or replaced.
		Check if blade is fixed	Blade must turn so that
		correctly on shaft.	air flow only can be
			sucked in and blown out
			in the right places. Blade
			must cover 10mm of
			shaft end, on two-step fan
		Check id timer is set in	Turn14mmtimer.	forward.
No-Frost		defrosting position.
No-Frost	Evaporator blocked	Check for snug fit of doors,	Repair leakage. Check
	by ice.	cable or tube wall ducts.	electric connections and
		Check if timer is under	contact unit of timer.
		tension when set at
		defrosting (remember that
		timer is only under is under
		tension when freezer
		thermostat is cut in). Check
		bimetallic thermostat and
		thermal fuse. Bimetallic
		thermostat can only be
		checked when the
		evaporator is cold (colder
		than 5°C). Check if heating
		element is under tension.
		Furthermore, when the
		doors have been open for a
		long time, the evaporator
		may be blocked by ice.Even
		though the compressor runs
		continuously, up to 10
		hours will be elapsed before
		the next defrosting takes
		place. There will be no
		cooling in this period.
Refrigerates/freezes	Capillary tube	Mount valve on charging	See section 4.1 and 4.1.1
too little or not at all.	completely or	pipe. Measure suction
Compressor runs	partially blocked	pressure. Check pressure
continuously.	(material from filter	equalizing time. Cut
	in capillary tube	capillary tube
	opening). Capillary	approximately 5cm after
	tube is inserted so far	filter. Blow N2 through
	up in the filter that it	charging pipe and check
	touches the filter net.	flow through capillary tube
		d filt

6.