EverFocus eDR1680 Series Post-Recording, Alarm Output, Buzzer, Call Display, Log, Show Message

Post-Recording

Define the post-recording time (0~99 seconds) for corresponding camera. Default value is 10 Sec.

Alarm Output

To define which Alarm Output will be triggered when the Motion Action is triggered. Alarm Output 1,2,5,6 are NC type of signal, Alarm Output 3,4,7,8 are No type. Select N/A to disable alarm output.Default value is 1 (alarm output 1).

Buzzer

To activate (ON) buzzer or not (OFF) while motion is triggered. Default value is “ON”.

Call Display

If Call Display function is enabled (ON), the call monitor will switch to the focus camera when the Motion Action is triggered. Default value is “ON”.

Log

Log to event log list or not. Please refer to Event Log for the details. Default value is “ON”.

Show Message

To display the alarm message or not when the Motion Action is triggered. Default value is “ON”.

E-mail

To activate the E-mail notification function or not when the Motion Action is triggered. The E-mail will be send to the defined receivers with an attached file, which contains the video graphic file f the triggered moment. Please refer to E-Mail Configuration for detail setting. (Note)

Network Alarm

Reserved for the PowerCom (Optional) users. Please refer to the PowerCom user manual for the detail information.

Note: If a new motion action is happened during the post record time from the previous triggered motion, there will be no notification sending for the corresponding action.

22