(10)EDIT MULTIPLE MOTION AREA
Enter a desired channel, and press SELECT to edit a motion area. Please make sure that MOTION is set as “Enable” before entering the motion detection area.
In the motion edit mode:
The default motion area of each camera is entire screen which displays in light green.
Press COPY to start to set an area.
Then press SEARCH to end and enable the area, or press PAUSE to end and disable the area.
Dial JOG to select a horizontal 
or
a vertical 
area, and press ENTER
to switch a horizontal 
or vertical area.
Press MENU to quit the motion area edit.
?To test a motion area: Grids will turn into light red from light green when a motion is detected.
?To clean up the entire area: Press PLAY to clean up the entire motion area.
?To get a motion area setting hint: Press DISPLAY to get a hint window (shows below) in motion
edit mode.
MENU | - EXIT |
COPY | - SELECT AREA |
ENTER | - CHANGE DIR |
SEARCH | - ON AREA |
PAUSE | - OFF AREA |
|
|
41
