EverFocus ESM316T002R user manual LLDP Configurations, Hint§, LLDP Settings

to the sum of the weights of all queues. (This is the default selection.)

■Weight-round-robin - Share bandwidth at the egress ports by using the scheduling weights for queues 1 through 8 respectively. WRR specifies a relative weight for each queue that determines the percentage of service time the switch services each queue before moving on to the next queue.

■Queue ID - Output queue buffer. (Range: 1-8, where 8 is the highest priority queue)

■Weight - Set a new weight for the selected traffic class. (Range: Strict or 1-15)

Use queue weights 1-15 for queues to allocate service time based on WFQ or WRR. Queue weights must be configured in ascendant manner, assigning more weight to each higher numbered queue.

Strict priority requires all traffic in the queue to be processed before lower priority queues are serviced.

LLDP Configurations

LLDP is a Layer 2 protocol that uses periodic broadcasts to advertise information about the sending device.

Web Smart switch interface

To configure global and port settings for LLDP:

1.Click Configuration, LLDP, LLDP Settings.

2.Enable LLDP for the switch.

3.If required, modified other LLDP parameters.

4.For one or a group of ports, set the LLDP mode.

5.Click Apply.

Figure 24: LLDP Settings

Hint§

The following parameters are shown on the LLDP Settings.

33