Bandwidth Control Setting | EverFocus ESM316T002R manual

Bandwidth Control Setting

This function allows the network manager to control the maximum rate for traffic received on a port or transmitted from a port. Rate limiting is configured on ports at the edge of a network to limit traffic into or out of the switch. Packets that exceed the acceptable amount of traffic are dropped.

Rate limiting can be applied to individual ports or trunks. When an interface is configured with this feature, the traffic rate will be monitored by the hardware to verify conformity. Non-conforming traffic is dropped, conforming traffic is forwarded without any changes. Input and output rate limits can be enabled or disabled for individual interfaces.

Web Smart switch interface

To configure bandwidth control:

1.Click Configuration, Bandwidth Control.

2.Select the ports to configure.

3.Set Type to Ingress or Egress .

4.Set State to Enable.

5.Configure the maximum rate allowed on the ports.

6.Click Apply.

Figure 29: bandwidth control

Hint§

The following parameters are shown on the LLDP Neighbors page. ■Port - Display the port/trunk number.

40

Image 40

EverFocus ESM316T002R user manual Bandwidth Control Setting, Bandwidth control

Contents

Gigabit Managed Ethernet Switch 16 PoE+ Ports Content Monitoring About this Guide Introduction Web Browser Login Popping Up Window Logging Web-Based Management Interface IP Address Setting System Information IPv6 Address Setting Hint§ Port Setting User Account Port Setting Configuration Trunk Group Setting Trunk Distribution Algorithm Setting Trunk Distribution Algorithm SettingPage Lacp Setting Lacp Setting Static Vlan Table Setting Static Vlan Table Setting Vlan Port Setting Vlan Port Setting VLAN-Stacking Table Setting VLAN-Stacking Table Setting Vlan Stacking Setting Vlan Stacking Setting Hint§ Igmp Multicast Group Information Multicast Entry Table Igmp Snooping Igmp Snooping Igmp Global Setting Igmp Vlan Setting Hint§ Spanning tree settings Spanning TreePage Spanning Tree Port Setting Spanning tree port settingsPage Quality of Service QoS Port-based Priority Setting DSCP-based Priority Setting DSCP-based Priority Setting Priority to Queue Mapping Setting Priority to Queue Mapping Setting Packet Scheduling Setting Packet Scheduling Setting Lldp Configurations Lldp Settings Lldp Neighbors Lldp Neighbors Snmp Setting Trap Receivers Setting Port Mirroring Setting Port mirroring Port Security Setting Port securityPage Bandwidth Control Setting Bandwidth controlPage Jumbo Frame Setting Jumbo Frame Setting Management Access Filter Management Access Filter Power over Ethernet Setting Power over Ethernet Security MAC Address Information Static MAC Setting Static MAC Setting MAC Filtering Setting 802.1x Setting 802.1x Setting 802.1x Port Setting 802.1x Port Setting IP Filter Configurations IP Filter ConfigurationsPage Storm Control settings Storm Control settings Port Isolation Port Isolation Defence Engine Defence Engine Monitoring Port Statistics Information Http Upgrade Http Upgrade Reset Factory Defaults Reset Reboot Specifications