Evolve Communications RD5000 manual Connect RemoteLinker* Cable

Getting Started

Connect RemoteLinker* Cable

Before you connect the RemoteLinker* cable, you should determine the COM port to which you will be attaching the cable. If your computer is on, perform the shutdown procedure recommended by the manufacturer and turn it off. Turn your computer back on after connecting the cable as indicated below.

Connect the small end of the cable to the bottom of your GUIDE Remote.

Connect the large end of the cable to the PC serial port.

Note	If you have more than one serial port, make sure that the RemoteLinker*
	software is configured to the one that you’re using. To access COM port
	settings, right-click on the RemoteLinker icon	located in the lower right
	hand corner of your computer screen. Choose Settings. Select the correct
	COM port to which you will be connecting the cable and click Apply.

10 Activate Remote Control *Trademark